Model reference Multiple regional model references

Bosch Professional
by the model.

Explore documented models by tool family. Match the actual regional identity and complete instructions before using any model-specific guidance.

Identify your tool

Circular saws

Explore the collection

Cordless circular saw

GKS 18V-57-2

Original identified blade, commissioned actual power, source-specific at-tool extraction and independent depth/bevel locks precede one supported square sample.

Model, manuals & limits

More guides for this brand

Bosch GKS 18V-57-2 UK: qualify the original system and a straightedge-guided square sample

Use the exact right-blade D1P controls, original qualified blade, commissioned power and installed 230 mbar/36 l/s extraction for one clamped-straightedge wood sample and complete acceptance.

Explore the collection

Identify your tool

Jigsaws

Explore the collection

Jigsaw

GST 18V-125 S

United Kingdom

The S uses a sliding on/off switch, stroke-rate preselection and a separate worklight control rather than the B trigger routine.

Model, manuals & limits

More guides for this brand

Prove a permitted bevel on a loose wood test piece

Check permitted Bosch accessories, tilted blade clearance and both faces of the sample.

Explore the collection

Stop repeated blade breakage with an external setup review

Inspect blade fit, under-work clearance and twisting forces before replacing a broken blade.

Explore the collection

Match a jigsaw blade to curves, thickness and surface requirements

Check shank compatibility, working length and turning width, then verify the required surface finish on matching scrap.

Explore the collection

Bosch GST 18V-125 B or S: compare the operating routine

Compare trigger and sliding-switch workflows, support and permitted accessories rather than unsupported performance rankings.

Explore the collection

Bosch GST 18V-125 B: prepare a controlled first wood cut

Use the bow-handle GST 18V-125 B on a supported wood sample before committing a finished panel.

Explore the collection

Bosch GST 18V-125 S: rehearse barrel-grip control

Plan the S switch access, curved route and supported stopping point before starting a loose wood sample.

Explore the collection

Separate blade wear, feed and binding when a wood edge burns

Stop a scorching cut, inspect the external setup and establish a clean sample before continuing.

Explore the collection

Diagnose a straight top line with a sloping bottom edge

Separate layout, blade installation, support and feed effects before blaming the base angle.

Explore the collection

Clear external dust paths with power isolated

Inspect removable dust components and restore the model-specific extraction arrangement without opening the saw.

Explore the collection

Cut a rounded hand opening in a loose storage-box panel

Plan a drilled entry, supported centre waste and smooth hand-finished edges without claiming load capacity.

Explore the collection

Cut a decorative oval through supported stages

Test the narrow ends and keep the retained oval supported as surrounding waste is removed.

Explore the collection

Round a loose shelf corner with a supported curved cut

Test the curve, support its waste and leave a hand-finishing allowance before cutting an uninstalled shelf blank.

Explore the collection

Inspect a stored jigsaw before returning it to work

Recheck identity, external condition and controls before proving the setup on supported scrap.

Explore the collection

Set a straightedge from the actual blade-to-base offset

Use a matching sample to establish the guide position, kerf allowance and cut-face accuracy before cutting a household panel.

Explore the collection

Keep thin plywood supported without hiding the blade route

Control panel vibration with planned support, secure workholding and a clear full blade stroke.

Explore the collection

Find your next answer.

Search guide titles, summaries, brands, and model names.

Tab to a result · Enter to open · Esc to close