The B uses a lock-off, pressure-sensitive trigger and stroke-rate preselection; the shared manual separates it from the S.
Verified setup distinction
The B uses a lock-off, pressure-sensitive trigger and stroke-rate preselection; the shared manual separates it from the S.
Check before you follow
Identity & documentation.
- Brand
- Bosch Professional
- Model
- GST 18V-125 B
- Tool type
- Jigsaw
- Market
- United Kingdom
- Catalog number
- 06015B3000
- Manual revision used
- 2025-09-10
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Only the listed regional model is covered; verify the nameplate before using accessories.
- Manufacturer documents checked; no hands-on performance testing.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Bosch Professional: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- Bosch GST 18V-125 B
Use the bow-handle GST 18V-125 B on a supported wood sample before committing a finished panel.
- Bosch B versus S
Compare trigger and sliding-switch workflows, support and permitted accessories rather than unsupported performance rankings.
- Round a shelf corner
Test the curve, support its waste and leave a hand-finishing allowance before cutting an uninstalled shelf blank.
- Set a straightedge from the actual blade-to-base offset
Use a matching sample to establish the guide position, kerf allowance and cut-face accuracy before cutting a household panel.
- Keep thin plywood supported without hiding the blade route
Control panel vibration with planned support, secure workholding and a clear full blade stroke.
- Diagnose a straight top line with a sloping bottom edge
Separate layout, blade installation, support and feed effects before blaming the base angle.
- Separate blade wear, feed and binding when a wood edge burns
Stop a scorching cut, inspect the external setup and establish a clean sample before continuing.
- Clear external dust paths with power isolated
Inspect removable dust components and restore the model-specific extraction arrangement without opening the saw.
- Inspect a stored jigsaw before returning it to work
Recheck identity, external condition and controls before proving the setup on supported scrap.
- Match blade to the cut
Check shank compatibility, working length and turning width, then verify the required surface finish on matching scrap.
- Cut a rounded hand opening in a loose storage-box panel
Plan a drilled entry, supported centre waste and smooth hand-finished edges without claiming load capacity.
- Prove a permitted bevel on a loose wood test piece
Check permitted Bosch accessories, tilted blade clearance and both faces of the sample.
- Stop repeated blade breakage with an external setup review
Inspect blade fit, under-work clearance and twisting forces before replacing a broken blade.