The US JS313101 is a 120 V, 60 Hz, 5 A corded model; a hex screw secures its foot.
Verified setup distinction
The US JS313101 is a 120 V, 60 Hz, 5 A corded model; a hex screw secures its foot.
Check before you follow
Identity & documentation.
- Brand
- SKIL
- Model
- JS313101
- Tool type
- Jigsaw
- Market
- United States
- Catalog number
- JS313101
- US product listing
- JS313101
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Only the listed regional model is covered; verify the nameplate before using accessories.
- Manufacturer documents checked; no hands-on performance testing.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
SKIL: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- SKIL JS313101 setup
Check the US supply, hex-screw foot and complete cord route before cutting a supported wood sample.
- SKIL JS313101 versus JS314901
Compare the hex screw and bevel lever, speed selection and visibility on matching loose wood samples.
- Round a shelf corner
Test the curve, support its waste and leave a hand-finishing allowance before cutting an uninstalled shelf blank.
- Set a straightedge from the actual blade-to-base offset
Use a matching sample to establish the guide position, kerf allowance and cut-face accuracy before cutting a household panel.
- Keep thin plywood supported without hiding the blade route
Control panel vibration with planned support, secure workholding and a clear full blade stroke.
- Diagnose a straight top line with a sloping bottom edge
Separate layout, blade installation, support and feed effects before blaming the base angle.
- Separate blade wear, feed and binding when a wood edge burns
Stop a scorching cut, inspect the external setup and establish a clean sample before continuing.
- Check a zero-bevel cut before adjusting the base
Use a repeatable sample to separate fixed alignment from blade deflection.
- Check a corded jigsaw externally when it will not start
Inspect the disconnected power path and controls without opening the saw or bypassing protection.
- Match blade to the cut
Check shank compatibility, working length and turning width, then verify the required surface finish on matching scrap.