A 6½ in, 5/8 in-arbor body with separate front bevel and rear depth knobs, an either-side resetting lock-off and an asymmetric base width scale.

Current product establishes identity; exact 2020 official-hosted primary establishes bounded owner instructions, not latest supplied revision.

Identity and assembly

18 V DC, maximum 6½ in blade, 5/8 in arbor and 4,700 rpm. Original correct washers, spindle-flat engagement and blade screw are prerequisites; clockwise removal/counterclockwise tightening recognition does not authorize a partial fitting procedure.

Isolated depth and bevel

With the battery removed, secure front bevel knob F at zero and rear depth knob D. Blade projection must be less than one full tooth AND no more than ¼ in below the work.

Actual power approval

The owner needs actual supplement 987000-432 and complete instructions for an already commissioned genuine approved pack/charger pair. Both battery latches must engage; no new pair or charging tutorial is qualified here.

Width and guidance

The base scale measures up to 1 in left and 4 in right of the blade. The zero-degree notch and an actual scrap cut establish the useful kerf offset; use a clamped straightedge for ripping.

Starting and stopping

Press lock-off from either side, then trigger; reach full speed before entry. Release and wait for complete standstill before withdrawal, and confirm guard closure before setdown. Lock-off resets but is not physical isolation.

Check before you follow

Identity & documentation.

Brand
RYOBI
Model
P507
Tool type
Cordless circular saw
Market
US P507 matching 990000975 REV:05 dated 5-6-20; existing-owner document scope
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

990000975, 5-6-20 REV:05. Two depth limits retained together. No inferred replacement torque, generic dry-washer rule, extraction fitting or universal battery approval.

Keep the limits in view.

  • No latest-manual assertion, kit promise, new power pairing or charging tutorial, partial blade replacement, invented torque, pocket cut, nonwood blade, external extraction adapter or chemical-cleaning recipe.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

RYOBI: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • P507 documented-owner setup

    Match the 2020 P507 instructions and commissioned power system, secure the separate depth and bevel knobs, and confirm the asymmetric width scale with a supported guided sample.

  • Blade side and supported-base layout

    Normalize two documented saw views, locate the broad retained-base support and guide contact, then rehearse a complete isolated layout without inventing handedness rules.

  • Plywood face-and-edge trial

    Make and record a representative plywood sample, inspect both faces and retained dimensions, then repeat or hold before cutting the finished piece.

  • Post-drop P507 assessment

    Record the impact, isolate the saw, perform the exact guard and bumper checks, and keep dropped batteries or chargers out of use under the documented rule.