The TC-CG 3,6/1 Li uses an integrated battery and a red-to-green heating indication. Prepare a small supported craft assembly, let the tool become ready and use the support bar whenever you pause.

Start and wait

Hold the switch for approximately three seconds to start heating and wait for the red indicator to become green before feeding compatible 7 mm adhesive.

Indicators depend on the task

A flashing red light during charging is not interchangeable with an operating warning. Follow the matching charging or operating instructions rather than a generic LED chart.

Respect protective shutdown

Do not keep pressing the switch after a low-battery protective stop. Use the supplied charger and stop for service if the specified charging indication is absent.

Check before you follow

Identity & documentation.

Brand
Einhell
Model
TC-CG 3,6/1 Li
Tool type
Compact hot glue gun
Market
Germany
Catalog number
4522190 / Ident11029
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Keep the limits in view.

  • Do not repeatedly press the switch after protective low-battery shutdown.
  • An absent charging indication requires the manual's fault checks and service boundary, not battery disassembly.
  • A flashing red indicator has different meanings during charging and operation; do not copy another gun's LED table.
  • No internal maintenance or extraction of a partly melted stick.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

Einhell: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • TC-CG start, pause and finish

    Prepare the parts before heating, read the correct operating indicator and finish the session without repeated restart attempts or a hot tool in storage.

  • Match stick and temperature

    Use the gun identity, the adhesive label and the intended material together; a stick that fits the opening is not automatically the right one.

  • Bench setup and cooldown

    Separate the hot-tool zone, the workpiece and the finished-item area so a pause or shutdown does not create an unexpected contact hazard.

  • Battery pen or corded gun?

    Compare reach, working rhythm, adhesive choice and storage needs without mistaking a cordless label for battery heating or a power ranking.

  • Stop safely when a glue gun will not heat

    Stop immediately for damage, smoke or sparks; perform only the exact model’s normal external power, adhesive and readiness checks before qualified service.