The Dremel 940 uses 11 mm adhesive and a detachable lead for limited residual-heat work. It is not a battery gun: prepare a small non-structural task and keep the kickstand available before starting.
Match the 940 adhesive
Use the suitable original 11 mm adhesive. The 940 operating instructions specify 195°C; do not borrow a different model’s temperature or adhesive setting.
Residual heat has limits
Disconnecting the lead does not maintain powered heating. Return the gun safely to its stand and reheat as required rather than relying on a promised task duration.
Cold maintenance boundary
Any permitted 940 nozzle change requires a cold, disconnected tool. Its instructions do not apply to the 930.
Check before you follow
Identity & documentation.
- Brand
- Dremel
- Model
- 940
- Tool type
- Compact hot glue gun
- Market
- European/general English listing; check actual rated supply
- Catalog number
- F0130940JA
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Follow the manual's indoor-use boundary rather than broader outdoor marketing.
- No structural furniture, electrical-insulation, food-contact or wet-area repairs.
- Do not transfer nozzle-changing procedures between the 930 and 940.
- Drip control does not make the nozzle safe to touch.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Dremel: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- Dremel 940 residual heat
Prepare a short reachable decorative joint before detaching the 940 cord, and stop when the cooling adhesive no longer flows normally.
- Dremel 940 cold nozzle change
Use only the 940’s permitted cold, unplugged nozzle procedure and stop if the replacement will not seat normally.
- Plan alignment before a hot-glue joint sets
Establish visible cold alignment references, rehearse the tool-to-stand movement and place each decoration promptly without sliding through partly set glue.
- Pace a craft project when glue flow slows
Work in complete small joints, pause for the exact tool’s heating needs and never force feed to rescue an oversized application sequence.
- Compare battery, heating-base and residual-heat glue tools
GluePen heats from an integrated battery, Dremel 940 uses stored heat after cord removal, and P306 heats only in its battery-powered base.