A 235 mm corded saw with a movable 2.2 mm riving knife, half-tooth depth recommendation, two bevel locks and double parallel guide; the matched owner workflow stays square and excludes plunge cuts.

No new rail procedure inferred from guide-groove brand names; no kit or blade-conversion promise.

Matched blade and knife

Original documented 235 × 30 mm assembly, 4,500 rpm: maximum plate 2.0 mm, knife 2.2 mm, kerf 2.8 mm. The manual also lists 15.88 mm regionally; no interchangeable bore or flange reversal is inferred.

Knife checks

While unplugged, qualify both the curve-to-teeth gap and blade projection below the knife bottom, each no greater than 5 mm. Knife and guard must return freely and automatically; no plunge cuts.

Depth and bevel

With the plug removed, lock depth screw 19 for no more than half-tooth projection; both bevel screws 9 secure zero. Stop 6 extends the range to 48° but is not a lock.

Parallel guide

With the plug removed, align the edge-following fence rail parallel to the blade, not the transverse bars. Rail down follows a workpiece edge; tighten front screw 8 then rear screw 8 and verify width by sample.

Supply and dust

Match actual nameplate voltage/frequency and use upstream RCD at most 30 mA. With the plug removed, push nozzle 1 fully in, rotate, pull out to lock in 45° steps and connect suitable extraction.

Check before you follow

Identity & documentation.

Brand
Metabo
Model
KS 85 FS
Tool type
Corded circular saw
Market
EU product 601085000, service 01085000; actual 220–240 V / 50–60 Hz nameplate match and original 30 mm assembly required
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Current service 01085000 links 17027686_00_0526 and general safety 17030000_00_1025; actual owner identity and nameplate remain prerequisites.

Keep the limits in view.

  • No bore conversion, partial blade or knife replacement, guessed torque, plunge, rail installation, nonwood sample or service calibration. The multi-region 15.88 mm listing does not authorize interchange.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

Metabo: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • KS 85 FS riving-knife owner

    Qualify the original regional blade and riving knife, check both knife clearances, set half-tooth depth and two bevel locks, then verify the double fence and indexed extraction nozzle.

  • Replacement blade: qualify every gate

    Build a complete blade-selection record for diameter, bore, speed, material and riving-knife constraints, with exact regional examples and stop outcomes.

  • KS 55 FS versus KS 85 FS owner choice

    Compare actual depth needs, the KS 85 FS riving-knife conditions, distinct parallel guides and real supply/support/extraction requirements without ranking safety or inventing fitting procedures.