B12A power identity, clip-in jaws and pad-specific speed limits for a complete small-surface sanding task.

B12A is not AMPSHARE

Match the 12 V B12A with an already qualified ALG 30, ALG 50 or ALG 80 and its actual instructions; no battery adapter or first-charge procedure is supplied.

Jaws together before clip-in

With the battery removed, clean the holder. If jaws are open, move the lever forward and back to reset them together, then clip the approved accessory in straight.

No open-lever running

Never actuate the lever while running or start with it open; never run with open jaws and no accessory. Keep fingers out of the mechanism.

Small pad versus heavy exception

Small triangular pads use 4–6, round/large triangular at most 4. The specified heavy 115 mm plate and tile-joint kit have a narrow level-2 damping-overload correction.

Check before you follow

Identity & documentation.

Brand
FEIN
Model
AMM 300 Plus
Tool type
Cordless oscillating multi-tool
Market
United States / Select 71293262090 / FEIN 12 V interface
Catalog number
71293262090
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Keep the limits in view.

  • Documentation-based, not hands-on testing.
  • No AS equivalence, Max interface, new kit or charging tutorial.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

FEIN: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • AMM 300 Plus 12 V owner

    Match the B12A system, reset and clip in the approved accessory, then finish a secured wood sample with the correct small-pad speed and dust controls.

  • FEIN versus Metabo Plus-holder decision

    Compare exact clip-in and quarter-turn pin responsibilities, pad-specific settings, dust scope and separate power systems before a small-wood sanding project.

  • Barewood inner-corner sanding

    Use an approved AMM 300 Plus small triangular system to finish an accessible flat face, preserve the adjoining face and stop where full-pad access ends.