A separate lamp switch, rear depth lever and front bevel clamping screw define this original-assembly corded owner workflow. The shared manual does not grant the F an FA electric brake.

Original assembly

185 mm / 7-1/4 in blade, current US 5/8 in arbor and 5800 rpm identity; retain the correctly qualified original wood assembly. Current D-45989-1 listing is not proof of an older carton.

Separate depth and bevel

Unplug before setting stock depth with the rear lever and zero bevel with the front clamping screw. The manual specifies no more than one tooth beneath the work; no MG positive-stop mechanics are transferred.

A and B references

A is the square-cut sight position and B is 45 degrees. Confirm actual kerf and guide offset on supported scrap rather than treating the mark as a dimension guarantee.

Independent lamp switch

The lamp has its own ON/OFF switch. Do not stare into the source; turn it off when not using the saw. Lamp state is neither blade standstill nor physical disconnection.

Trigger and coast-down

The ordinary trigger must return OFF before plugging in. FA-only electric-brake instructions do not apply to 5007F. Require complete standstill and lower-guard closure before setdown.

Supported guide sample

With power disconnected, secure the matched guide rule by the front base screw or qualify a clamped straightedge offset. Keep the broad base on supported retained wood and the entire cord route clear.

Check before you follow

Identity & documentation.

Brand
Makita
Model
5007F
Tool type
Corded circular saw
Market
US 5007F, actual nameplate and current product-linked 884404A949 shared document
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Current exact US manual bridge freshly verified. Shared North American cover/back retained; no inferred issue date, current old-owner kit contents or resolution of conflicting weight figures.

Keep the limits in view.

  • US 5007F matching actual nameplate and 884404A949; existing correctly installed approved wood assembly, square edge-entry sample only. No FA brake, 5008 blade size, MG stop system, kit promise, supply conversion, replacement, rail system, calibration or brush/chemical service tutorial.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

Makita: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • 5007F corded square sample

    Qualify the original US 5007F assembly, distinguish lamp and motor controls, lock depth and square bevel, then verify a guided supported wood sample.

  • 5007F versus 5007MG control habits

    Compare exact lamp behavior, bevel locking mechanisms and documented square capacity, then make a model-specific ownership choice without borrowing brake or accessory claims.