Separate rear depth and front bevel levers, a side-routing cord holder and a fully supported retained base define this dated-document square wood acceptance task.
Document and blade identity
Current HPT links Hitachi C99722362 F / 707. The original documented blade is 184 mm / 15.9 mm; manual 115429 and current product 372102 are not assumed interchangeable.
Two lever (A) controls
Unplug before adjusting. The rear depth lever controls body height over the supported base; the front bevel lever independently locks zero inclination. Use less-than-full-tooth projection and secure both.
Spindle lock distinction
The spindle lock is for blade work, not depth setting or braking. Retain the correctly fitted original assembly and released lock; no partial replacement procedure.
Matched optional guide
Guide 302691, wing bolt 302697 and lock spring 947859 form the documented optional system. With power disconnected, position and secure it clear of the blade and lower guard; either base-entry side is documented.
Side-directed cord holder
With power disconnected, route the cord through the actual holder and check the entire moving cable path. The holder cannot prevent every snag or replace two-handed control.
Supported sample and setdown
Keep the broad base on supported retained wood, reach full speed before contact and feed straight. Complete stop and closed lower guard are both required before setdown; current product lists no electric brake.
Check before you follow
Identity & documentation.
- Brand
- Metabo HPT
- Model
- C7SB3
- Tool type
- Corded circular saw
- Market
- US C7SB3, dated C99722362 F / 707; actual nameplate-matched 120 V AC 60 Hz only
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Manufacturer currently links the 2017 Hitachi-authored instructions. Blade-number conflict is retained; no current carton, replacement equivalence, DC workflow or fixed stopping-time claim.
Keep the limits in view.
- Exact document-matched original wood assembly and actual nameplate-matched 120 V AC 60 Hz only. No current/old blade-number equivalence, replacement procedure, DC workflow, inferred lock-off, electric brake timing, pocket cut, restart, high-angle task, rail adapter or internal service.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Metabo HPT: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- C7SB3 corded owner sample
Match the dated manufacturer instructions, lock depth and zero bevel independently, route the cord holder and verify a supported square wood sample.
- C7SB3 versus C3607DB systems
Choose a documented corded or commissioned cordless route for one supported wood task, without torque rankings or borrowed controls.