An actual separate outer flange and 5 mm hex-key route, with positively identified no-adapter wood blade, dial 2–12 and a complete supported cut.
Original outer flange and 5 mm key
With OFF, complete stop and battery removed, place the tool upside down, remove the bolt, outer flange, old accessory and any adapter; clean the original parts, refit the qualified no-adapter blade/outer flange/bolt and tighten securely with the correct key. Remove the key before power.
Six profiles are not universal fit
The actual chart shows two no-adapter profiles and four adapter-dependent profiles with specific faces. This project uses only a positively identified recommended original wood blade in a no-adapter route; no brand names are inferred from outlines.
Dial 2–12 and slide I/0
The actual endpoints are 2 at 5,000 OPM and 12 at 20,000 OPM. Start with the blade clear, reach selected full speed before wood contact, use controlled moderate feed and stop fully before setdown. No A mode or invented trigger lock.
Distinct four/eight-flash signals
During qualified operation, one light flashing four times means under 10%; eight times means empty/no run. Hot-battery gauge flashing is separately described without an alternating pattern or named colour. Establish OFF and isolation; unexplained faults require service.
Check before you follow
Identity & documentation.
- Brand
- Milwaukee
- Model
- 2426-20
- Tool type
- Cordless oscillating multi-tool
- Market
- United States; actual 2426-20 and 58-14-2426d4
- Catalog number
- 2426-20
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- One 2426 body, not an extra 2426-22 kit or 2526/2836 mechanism.
- Only the positively matched original recommended wood blade/no-adapter profile is the project route; all adapter routes require separate exact qualification.
- Actual commissioned M12 power instructions remain mandatory; no new charging, trigger-lock or LED-colour inference.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Milwaukee: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- 2426 original flange owner
Identify the original no-adapter wood blade, rebuild the separate-flange clamp and complete an inspected loose-stock cut with the actual dial and slide switch.