Use the original screw-mounted blade, actual barrel grip and stopped-before-withdrawal sequence for a complete visible loose-wood cut.
Original bolt and full flange engagement
OFF, full stop and unplug before removal. Use the correct hex wrench to remove the original installation bolt and old accessory. Seat all matching flange protrusions in the native blade holes, correctly oriented; tighten the original bolt firmly and remove the key.
Original blade and known wood
The historical US flyer identifies A-95255; the same-part 2016 table supports wood cutting. Positively identify the actual original blade and condition, clamp retained dry loose stock and independently support waste.
Dial travel and actual slide stop
Select within 1–5 through intermediate numbers, never force across the endpoints. Cutting guidance is 3–5. Slide I starts and O stops; the exact manual requires full blade stop before withdrawal from the workpiece.
Actual grip, supply and separate extraction
Use the actual insulated barrel grip with hand and face clear of the accessory. Match US 120 V/3 A nameplate and intact supply. Optional felt-ring/pad extraction is a separately qualified sanding assembly, not cutting capture.
Check before you follow
Identity & documentation.
- Brand
- Makita
- Model
- TM3000C
- Tool type
- Corded oscillating multi-tool
- Market
- United States; discontinued TM3000CX5 kit / TM3000C body
- Catalog number
- TM3000CX5
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Discontinued exact US body only; one CX5 kit body, no TM3010 replacement equivalence.
- Actual original A-95255 identity and usable reach required; omit conflicting width and no replacement-blade inference.
- No adapter route, powered fault test or sanding-attachment cutting-capture claim.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Makita: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- TM3000C hex-bolt owner
Match the discontinued US body and original A-95255, complete a supported wood cut and stop fully before withdrawing the blade.