A trained-owner Nuron system with controlled two-click clamping, remembered speed and a visible softwood sample rather than blind installed work.
Qualified Nuron power prerequisite
Use only an already commissioned, documented Nuron B 22 battery and approved charger with the actual matching instructions. The blank referenced table in this PDF cannot establish a named charging pair.
Closed to change, open to lock
With the battery removed, turn the lever counterclockwise fully past the first detent to close the jaws, lower the aligned body onto the insert, then close clockwise under control so the jaws open and lock.
Six stages with retained memory
Select using plus/minus only while OFF or unloaded. The OFF display expires after 15 seconds, but retains the stage; the illustration of stage 4 is not a cutting recommendation.
Status does not certify battery condition
Short press requests charge/fault status; longer than three seconds requests health. Recheck engagement after pressing an installed battery. The health check cannot detect some misuse damage.
Check before you follow
Identity & documentation.
- Brand
- Hilti
- Model
- SMT 6-22
- Tool type
- Cordless oscillating multi-tool
- Market
- Australia / generation 01
- Catalog number
- SMT 6-22
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Documentation-based, not hands-on testing.
- No named charging pair, parallel-guide cutting tutorial or battery repair.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Hilti: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- SMT 6-22 qualified owner system
Use the exact AU generation 01 instructions to qualify Nuron power, complete the two-click clamp, control remembered speed and accept a supported softwood sample.
- Exterior care and storage decision
Finish routine isolated care of the Milwaukee 2526-20 or Hilti SMT 6-22 without mixing housing, tool-contact and battery-contact methods.