Use the original eight-pin native clamp, exact centre-enable trigger controls and a qualified existing power system for a complete visible loose-wood sample.
Eight pins and flush native seating
Establish OFF, including cancelling any lock-ON, wait full standstill and remove the battery. Squeeze the clamp lever, remove the old cooled blade, clean shaft/holder and slide the original accessory onto all eight pins flush with the shaft; release and check securely while isolated.
Centre enable versus side locking
With trigger released, button D fully to either side locks OFF; centre enables normal trigger. With trigger depressed, either side locks ON. Press the trigger again and release to cancel lock-ON and stop; no five-minute shutdown is asserted.
Qualified existing battery and charger
Use the actual already commissioned DCB203/DCB112 with complete own instructions, supported by the dated final table. 20 V Max is 18 V nominal. Do not use a battery or charger that was dropped, sharply impacted or damaged; hold for qualified handling.
Actual grip and side setdown
Use the Figure 16 main-handle grip with other hand and body clear of the blade. LED remains on 20 seconds after release and is not readiness proof. For this sample, stop fully before withdrawal, lay the tool on its side safely and remove the pack before acceptance.
Check before you follow
Identity & documentation.
- Brand
- DEWALT
- Model
- DCS355 Type 1
- Tool type
- Cordless oscillating multi-tool
- Market
- Canada; physical Type 1 with supplied N434640 JUN15 instructions
- Catalog number
- DCS355
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Dated physical Canadian Type 1 and supplied N434640 JUN15 match only; not all DCS355 bodies or a current kit claim.
- Actual commissioned DCB203/DCB112 and original documented native DeWalt wood blade required; no new charging, guessed SKU or adapter.
- No DCS353 timer, DWE315 lock-button transfer, numeric wood OPM or borrowed dust attachment.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
DEWALT: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- DCS355 CA Type 1 owner
Match the physical Canadian Type 1 and June 2015 manual, qualify the existing power and blade, and complete an isolated-acceptance wood sample.