Qualify the existing assembly and commissioned power, distinguish depth and front bevel controls, verify native extraction and accept a complete supported square sample.
Original assembly
Original approved 184 mm/5⁄8-inch wood blade rated at least 5300 rpm, correct clean flush washers and intact bolt already qualified. No new fitting or replacement recipe.
Commissioned single pack
Actual BY519601 4 Ah / QC536001 already commissioned under complete own instructions; no pictured USB-C equivalence or current-kit promise.
Isolated controls and guard
Release trigger, wait for standstill and remove pack completely before checks. Guard must close instantly and clear blade/parts at all angles and depths; ordinary cuts automatic.
Depth and square sightline
With pack removed, main-handle-side depth lever and actual indicator set through-cut with less than a full tooth. Separate front bevel lever locks zero; right 0° notch is the square sightline.
Existing native extraction
Already correctly installed native port and documented suitable 32 mm hose/extractor required; connect isolated, then operate and check before cutting. Hose cannot interfere with guard or either hand.
Trigger, LED and acceptance
Thumb lock-off then held trigger, two designated handles and full speed before contact. Actual full stop/guard coverage, not approximately ten-second LED extinction, precede setdown and battery-out acceptance.
Check before you follow
Identity & documentation.
- Brand
- SKIL
- Model
- CR5440B-00
- Tool type
- Cordless circular saw
- Market
- US, actual CR5440B-00 and supplied 10/22 manual match
- Catalog number
- CR5440B-00
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Current -1C USB-C configuration/image and legacy BY519601/QC536001 included text differ. Actual body/document/power prerequisites govern. Strict partial-tooth safety rule overrides later no-more-than-one wording; LED delay is not a stop timer.
Keep the limits in view.
- Actual CR5440B-00 / 10/22 original approved 184 mm, 5/8-inch wood assembly rated at least 5300 rpm; commissioned BY519601/QC536001 and existing native 32 mm active extraction only. Preserve current USB-C/-1C versus legacy included-list conflict. No kit promise, new power/charging, track, fitting, plunge, high-angle or timed-brake recipe.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
SKIL: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- CR5440B original-system owner
Use the matched 10/22 body, original wood assembly, commissioned BY519601/QC536001 and native extraction for a supported square sample through acceptance.