A rear-handle body requiring both packs removed for setup, a bottom-contour depth reference and the right foot edge against a board guide.
Current product requires at least 5 Ah; this owner scope uses two BY519603 5 Ah only. Older battery charger list chronology and unresolved charger visual/download gate are retained.
Both packs removed
Switch off, release and remove each pack, then confirm both mounts empty. A single missing pack prevents running but does not replace the prescribed two-pack isolation.
Depth reference
With both packs removed, align the bottom contour of the depth lever with the bracket, lock it and confirm less than one full tooth below the actual work.
Square reference
Large notch is zero; small notch is 45 degrees. Lock zero bevel and verify actual kerf on scrap. No over-45 stop-spring tutorial.
Guidance and dust
Use the right foot edge against a clamped board guide. The 32 mm hose at the auxiliary handle must not obstruct the guard or cutting travel.
Original assembly
184 mm / 7¼ in wood blade, 16 mm / 5/8 in arbor and rating at least 5,300 rpm. Correct clean flush washers and original hardware are prerequisites, not a partial fitting recipe.
Check before you follow
Identity & documentation.
- Brand
- SKIL
- Model
- CR5429B-00
- Tool type
- Two-pack cordless rear-handle circular saw
- Market
- US original-assembly owner, actual two BY519603 5 Ah packs; commissioned system only
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Tool printed revision not identified. Battery 01/19 source reused unchanged; current product pairing does not become a new charging tutorial or reciprocal old-table approval.
Keep the limits in view.
- No charging setup or charger LED tutorial, reciprocal old battery-table approval claim, kit promise, smaller pack substitution, blade replacement, arbor modification, plunge or nonwood task.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
SKIL: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- CR5429 two-pack owner
Use the already commissioned exact two-pack system, the depth lever bottom contour, large zero notch and right-side board guide for a supported wood sample.