Qualify original assembly, actual supply and native active extraction before a supported square sample; distinguish the always-plugged lamp, MGA brake and separate angle range/lock.
Original 8¼-inch assembly
Actual approved 210 mm/8¼-inch wood blade, original matched 5/8-inch assembly, flanges/ring/bolt and actual rating qualification required. No numerical blade-rating threshold is invented from 5200 rpm motor speed.
Supply and complete native extraction
Actual nameplate supply governs; historical US leaflet says 120 V/15 A. OFF/full stop/unplug before connection checks. Existing screwed native joint and documented suitable Makita hose/extractor must be qualified and active; no universal diameter.
Depth versus bevel range
Unplugged rear depth lever sets through-cut with less than a full tooth. Separate front bevel lever locks actual zero; 22.5°/45°/50° stopper selects range, not lock.
Right A sightline
Right A is the straight-cut reference, left B is 45°. Verify the actual line on equally safe scrap; no factory offset or angled-cut tutorial.
Lamp and brake boundaries
Lamp lights whenever plugged until unplugged; no separate lamp switch or energized diagnostic test. MGA brake has no guaranteed stop time and never substitutes for guard; consistent failure to stop quickly requires Makita service.
Support and completion
Front grip and rear handle, full speed before contact, retained wide-base support and independent waste; normal release/full stop/guard coverage before setdown, then unplugged measurement. No brush break-in or alignment recipe.
Check before you follow
Identity & documentation.
- Brand
- Makita
- Model
- 5008MGA
- Tool type
- Corded circular saw
- Market
- US discontinued existing-owner scope; actual supplied 884738A940 match
- Catalog number
- 5008MGA
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Current official US page says discontinued. Historical leaflet supports US 5/8-inch and 120 V/15 A identity only; no current kit, numerical blade-rating rule from motor speed, 5007 alias or MGA brake transfer to MG.
Keep the limits in view.
- Discontinued US 5008MGA / actual supplied 884738A940 original approved 210 mm/8¼-inch, actual 5/8-inch wood assembly and rating qualification only. Exact actual supply and complete already-qualified screwed native joint/Makita active extraction required. No invented numerical blade-rating rule, MG brake transfer, current kit, ring/fitting, brush break-in/fault test, high-angle, rail/plunge/restart or electrical repair.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Makita: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- 5008MGA existing owner
Match the original US assembly, supply and native extraction, then distinguish the depth, angle-range, lamp and brake controls before a complete supported crosscut.