A 165 mm cordless body with opposite depth/bevel lever directions, a clip-in extraction port, inner-edge kerf indicator and DCS565 worklight; the sample uses an already commissioned exact power system.
Exact original wood assembly
Type 1 N862094 specifies 165 mm blades with correct actual spindle hole and blade speed capability at least the saw speed. No inferred bore, new fitting, oil or torque instruction; wood only.
Opposite adjustment directions
With battery removed, depth lever 4 loosens clockwise and tightens counterclockwise; bevel lever 10 loosens counterclockwise and tightens clockwise. This workflow sets zero degrees.
Half-tooth depth
With battery removed, set about half a tooth projecting below actual stock and retain the general less-than-full-tooth ceiling. Maximum zero-degree capacity is 54 mm, not the default setting.
Dust port and final depth
With battery removed, fully loosen depth, put the shoe lowest and push port 22 until the locks click. Restore and lock actual depth and verify guard/hose clearance before operation.
Kerf and retained support
The indicator aligns with the left inner blade side; kerf falls right into waste. Verify on scrap and keep the wider shoe on the supported retained piece.
Commissioned power and delayed light
Use the actual already approved DCB205/DCB107 system under its complete instructions; no charging tutorial or carton promise. DCS565 worklight delay is about 20 seconds, not blade-stop confirmation.
Check before you follow
Identity & documentation.
- Brand
- DeWalt
- Model
- DCS565
- Tool type
- Cordless circular saw
- Market
- North American Type 1 N862094 / 07/20 existing owner; original assembly and actual commissioned DCB205/DCB107
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
N862094 / 07/20, Type 1 manufacturer URL. New document-scoped owner prose; current product page and latest supplied-manual claims held.
Keep the limits in view.
- No latest-manual or carton claim, charger tutorial, inferred bore or speed number, replacement blade procedure, lubrication, nonwood cutting, pocket cut or abbreviated stall restart.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
DEWALT: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- DCS565 compact owner setup
Use the opposite depth and bevel locking directions correctly, fit the actual dust port and verify kerf allowance in a supported zero-degree wood cut.