Qualify the corded UK MM20 and original MM480, secure the original screw/washer interface and complete an inspectable loose-softwood cut.
Original screw, washer and key
OFF, full stop and unplug before change; cool old parts and use protective gloves. Loosen the original screw with the supplied key, remove the old open-slot accessory, clean and retain the original washer with bevel up in the holder-up view. Seat all pins flush, securely tighten the screw, check while isolated and remove the key before power.
Original MM480 wood qualification
Current exact UK product and actual chart 5 identify MM480. The softwood row is 8–10, not a capacity or universal setting. Actual original identity, intact condition, complete blade reach and loose known material remain hard gates.
Slide switch and documented speed ranges
Slide forward for ON and backward for OFF. The documented dial ranges span 10,000–21,000 OPM; preset isolated and use light repeated passes. This project chooses OFF and full standstill before withdrawal, then unplugged acceptance, without presenting that choice as a special OEM quotation.
UK supply, two hands and task dust controls
Match actual 220–240 V, 50/60 Hz, 250 W nameplate, intact cord and supplied UK plug. Use both hands with clear vents. Isolate tool and extractor for connections, then operate/check actual qualified dust equipment before cutting. The sanding-port figure does not establish saw-blade capture.
Check before you follow
Identity & documentation.
- Brand
- Dremel
- Model
- MM20
- Tool type
- Corded oscillating multi-tool
- Market
- United Kingdom; actual 220–240 V MM20 matching linked WEU February 2012 instructions
- Catalog number
- F013MM20JB
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Actual UK 220–240 V, 50/60 Hz, 250 W body/document match; one physical MM20, not a kit or MM20V alias.
- Only positively identified original MM480 with suitable material, condition and actual reach.
- No lever, generic battery/collet, US accessory-rating or sanding-port cutting-capture transfer.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
Dremel: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- MM20 UK hex-clamp project
Match the 250 W UK MM20, retain its original washer and key procedure, and complete a visible supported softwood cut.