Complete a visible loose-wood cut using the actual slide switch and separate dial only after the original installed blade and existing power system are positively qualified.
Installed assembly only; mounting remains held
With the switch OFF, full standstill and battery removed, require positively documented original recommended wood-blade identity and qualified installation. Actual pins must all engage and the blade sit flush. Appearance alone cannot certify assembly; any disturbance, looseness or uncertainty requires non-use and clarification/service.
Slide switch and separate dial
The actual manual uses forward ON and backward OFF, not the product marketing trigger wording. Dial 1–6 provides approximate 8,000–18,000 OPM references; uncertain settings require a low trial and gradual increase, not an invented universal wood setting.
Commissioned listed power only
20 V Max is 18 V nominal. Use an already commissioned original system from the final compatibility table with complete actual battery/charger instructions required on page 2. No new pairing, charging or battery/charger repair is taught.
Both hands and isolated acceptance
The cutting warning requires both hands despite the general one-hand illustration. Keep blade clear at start and hands away from the cutting path; for this sample stop fully before withdrawal, set the tool safely on its side and remove the pack before acceptance.
Check before you follow
Identity & documentation.
- Brand
- CRAFTSMAN
- Model
- CMCE500 Type 1
- Tool type
- Cordless oscillating multi-tool
- Market
- United States; physical Type 1 with supplied NA484461 09/23 match
- Catalog number
- CMCE500
- Evidence level
- Manufacturer documentation; no physical testing
A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.
Keep the limits in view.
- Actual US physical Type 1 and supplied NA484461 09/23 match; no Type 3 equivalence or new-buyer commissioning.
- Original installed recommended wood blade and manufacturer-qualified correct assembly must be documented before this project. Unknown or disturbed mounting remains non-use/qualified-service hold.
- No clamp operation, removal/refit/reorientation, invented SKU, generic fit, charging recipe or current kit promise.
Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.
Keep reading
CRAFTSMAN: explore this brand’s tool references
Guides for this model
Explore controls, comparisons and documentation for this exact model.
- CMCE500 installed-blade project
Qualify the original installed assembly and existing power, use the actual slide switch and dial, and finish a visible loose-wood cut without teaching the unresolved mounting sequence.