A trained existing owner first closes actual blade/document and paired depth gates, then uses a qualified small-base, Nuron and industrial-extraction arrangement for one ordinary square sample.

Professional exact-match gate

Only trained authorized personnel with actual US generation 02 small base/item 2422186 and matching supplied POS3 instructions may use this workflow. Large-base overview does not qualify its guide or rail features.

Original blade discrepancies

Actual original Hilti-recommended EN 847-1 wood blade, dimensions, hardware and rating at least the actual tool maximum must be qualified together. Preserve 190 mm/7-1/4 in conflict and manual 6250 rpm, 5/8 in, 0.7–1.8 mm plate/2.5 mm kerf; unknown assembly is HOLD, no replacement recipe.

Two depth conditions

With battery removed, release rear depth clamp, set by scissoring movement and secure. Actual approximate 5–10 mm extra depth AND less than one full tooth must both be established, otherwise HOLD for Hilti clarification; zero bevel only.

Guard and isolation

Release switch, wait complete standstill and fully remove battery before checks. Lower guard must close instantly and clear blade/parts at all angles and depths; faulty guard or spring requires Hilti Service.

Power and industrial extraction

Actual commissioned manual-listed Nuron pair under complete own instructions, plus suitable approved-class industrial vacuum and task mask/eye/hearing protection, are hard prerequisites. No photo equivalence, charging or universal hose fit.

Interruption is not AutoStart permission

Immediately release on/off and hold motionless until complete blade stop, then isolate safely. Never retain trigger or pull backwards to induce automatic restart; two seconds is not a stop guarantee. Normal completed cut still requires actual standstill and guard coverage before setdown.

Check before you follow

Identity & documentation.

Brand
Hilti
Model
SC 30WR-22 (02)
Tool type
Cordless circular saw
Market
United States, generation 02 small base, supplied 2427977 POS3 matched
Catalog number
2422186
Manual revision used
Pos. 3 | 20250207; PUB_5884027_000
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

190 mm versus 7-1/4 in, 70 versus 67 mm and 50 versus 53 degrees remain unresolved claims, not conversions. AutoStart is disclosed but excluded; release/hold/actual standstill/isolation governs interruption. B22-175 photo is not B22-170 table approval.

Keep the limits in view.

  • Trained authorized professional existing owner only; exact US generation 02/item 2422186 small base and supplied 2427977 POS3 match. Original assembly, permitted dimensions/rating and paired 5–10 mm/less-than-full-tooth depth must positively close or HOLD. Actual commissioned listed Nuron power and industrial extraction/mask required. No AutoStart recovery, fitting, internal chip cleaning, charging, rail/parallel-guide installation, interior plunge or large-base transfer.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

Hilti: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • SC 30WR-22 (02) conditional owner

    For trained authorized owners only: preserve actual blade and depth conflicts, qualify small-base power and industrial extraction, then complete a controlled crosscut without AutoStart recovery.