Actual supply and extension qualification, separate rear depth and front bevel levers, original 7000 rpm-or-higher blade and complete supported square sample.

Original wood assembly

Retain the qualified original 184 mm / 7-1/4 in, 5/8 in / 16 mm wood assembly; blade rating must be 7000 rpm or higher and meet actual warning-label constraints, not merely the 5500 rpm motor figure.

Conditional extension table

For verified 120 V and 15 A only, the manual 12–16 A row specifies minimum 14 AWG at 25 ft and 12 AWG at 50 ft; 100/150 ft not recommended. Actual total length, supply, markings and condition govern.

Independent settings

With the plug disconnected, use rear depth lever 12/scale 13 and front bevel lever 9/scale 14 separately. Set zero and less than a full tooth below the work; lock both securely.

Guard and grips

Unplug for lower-guard lever 7 checks at all angles and depths; require free instant closure. During ordinary cutting, use main handle 2 and auxiliary 3 with body beside the blade line.

Supported sample

Retained work clamped, both portions independently supported outside the blade path, wide shoe on retained work and waste free. Ripping requires a qualified guide and full cord clearance.

Stopping and service

Trigger 1 has no lock-on. Release, wait for actual complete stop and guard coverage, then unplug for inspection. No powered fault test, electrical reset, repair or timed-brake inference.

Check before you follow

Identity & documentation.

Brand
CRAFTSMAN
Model
CMES510
Tool type
Corded circular saw
Market
US CMES510, actual owner nameplate and N638218 08/18; QU Type 1 document route
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Current US product directly links QU/CMES510/1 N638218 08/18. Capacity and structured battery-field conflicts are retained; original assembly and actual supply only. Bevel component 9 is a lever despite one knob reference.

Keep the limits in view.

  • Exact US CMES510 owner matching N638218 08/18 via actual QU Type 1 route; original approved wood assembly only. Actual nameplate supply and cord qualification required. No CA substitution, capacity reconciliation, battery inference, electrical repair/reset, blade fitting, plunge, nonwood or timed-brake claim.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

CRAFTSMAN: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • CMES510 cord-qualified owner

    Match the actual supply, original 7000 rpm-or-higher blade, independent levers and supported route before accepting a square wood sample.