A known-profile original-assembly softwood sample with actual rail-free depth, both bevel locks, plunge return and active extraction.

Original assembly

Retain qualified original Expert for Wood T42, 140 mm / 20 mm, blade body 1.0–1.4 mm, tooth thickness/offset at most 2.4 mm and blade rating above 5500 rpm; no replacement procedure.

Motor and radio isolation

Release trigger, wait for standstill, then fully remove main battery without force. Installed GCY 42 retains separate coin-cell power; main-pack removal is not radio isolation.

Actual rail-free depth

With the main battery removed, use slider 36 and verify actual projection below work is less than one full tooth. Indicator 7 assumes a Bosch rail; do not invent a numeric no-rail offset.

Two bevel locks

With the main battery removed and base supported flat, set zero with both wing bolts 13 and 16 and secure both without twisting the handle/body into mismatched angles.

Known speed profile

Only a known unmodified six-speed default profile is covered: solid wood / original T42 uses level 6 at 5500 rpm. An unknown app configuration is a hold, not permission to reset or experiment.

Extraction and return

Use the actual qualified 35 mm hose at rotating ejector 18 with a suitable active extractor. Lock-off 2 also releases plunge; body rise returns and locks it. No interior plunge or rail setup.

Check before you follow

Identity & documentation.

Brand
Bosch
Model
GKT 18V-52 GC
Tool type
Cordless plunge circular saw
Market
Middle East / actual 06016B4000 and 3601FB4000 with A48 January 2025 instructions
Catalog number
06016B4000
Evidence level
Manufacturer documentation; no physical testing

A source check date records this research pass. It does not confirm that a manual is the newest possible revision, a tool is still in production, or a particular unit matches these documents.

Current exact Middle East product links A48 and GCY 42 6RX. Preserve less-than-full-tooth versus thickness-plus-tooth wording, speed-table inconsistencies and 45-degree capacity/scale conflict. No rail offset, current kit, other region or NC module equivalence inferred.

Keep the limits in view.

  • Exact Middle East 06016B4000 / 3601FB4000 under A48, qualified original T42 assembly rated above 5500 rpm, commissioned listed power and known unmodified six-speed profile. Square softwood edge entry with auxiliary board guide only; no rail commissioning, interior plunge, fitting, charging, app/reset/module work or unqualified regional transfer.

Read the instructions for the tool and any applicable battery or charger together. Routine owner care stays outside the housing; internal service belongs with the manufacturer or an authorized service provider.

Bosch: explore this brand’s tool references

Guides for this model

Explore controls, comparisons and documentation for this exact model.

  • GKT 18V-52 GC regional owner

    Match the Middle East A48 system, verify actual depth and both bevel locks, retain radio precautions and finish a guided softwood sample.